CNCGLASS-Black-EVA-Film-Catalog-2026-11-14

This catalog presents a black EVA encapsulant film from CNCGLASS, compounded from ethylene-vinyl acetate copolymer with the additives needed for photovoltaic module assembly. In the finished module the film seats the cells, holds them in position, and isolates them from weather so that electrical output is not lost to environmental attack.

After lamination, the film is required to keep its bond: peel strength after aging is specified to remain high enough for outdoor modules to stay free of delamination through a 25-year service life. The film is prepared to resist heat, humidity, and ultraviolet exposure, and it is resistant to potential-induced degradation (PID). On the laminator it is intended to run with a short cycle and high throughput.

The film is offered in a thickness range of 0.3–1.0 mm, widths up to 1,400 mm, and roll lengths of 150–350 m. Key published values include crosslinking of at least 75% (about 85% is given as a practical lamination target), tensile strength of at least 18 MPa, elongation of at least 500%, peel strength of at least 60 N/cm to glass and 40 N/cm to the backsheet, volume resistivity of at least 1 × 10¹⁵ Ω·cm, and dielectric breakdown strength of at least 26 kV/mm. UV and damp-heat aging (1,000 h) are both specified at a yellowness-index change of no more than 4.

The catalog also gives starting windows for single-chamber and two-chamber laminators, together with storage and handling notes: keep rolls cool and dry (not above 30 °C or 60% RH), prefer use within three months (up to six months storage), limit stacking to five layers, and use opened or cut film within 48 hours. Pricing, widths, thickness options, and packing details are available from CNC@CNCNEXT.COM.

Leave a Reply

Your email address will not be published. Required fields are marked *