CNCGLASS-White-Opaque-EVA-Interlayer-Film-QC-Performance-Summary-for-Architectural-Laminated-Glass

This CNCGLASS technical note summarises the quality-control performance of the CNCGLASS ultra-white opaque EVA interlayer film, a milky-white, light-blocking laminating film for architectural glass processing. The nominal thickness is 0.38 mm, with an ultra-white opaque colour and a matte embossed surface. Laminated with two plies of glass, the film produces a clean, uniformly white, translucent-free panel for privacy glazing, spandrel and decorative laminates where light transmission is not wanted. The evaluation covers appearance and dimensional quality, optical properties, mechanical properties, crosslinking behaviour, recommended lamination processing and storage. The film is produced in conformity with EN 14449:2005 and EN ISO 12543-4:2011 and is qualified for outdoor service. The document states that it is a CNCGLASS technical note and performance summary, not a third-party test certificate or a certificate of conformity, and that it does not authorise the use of any third-party laboratory mark.

Appearance quality was recorded as good, with no wrinkles, no contamination and no inclusions detected at the Φ ≤ 0.5 mm per 10 m² inspection level, and bubbles at that same size and area limit reported as ≤1. A single film ply transmits 0.5% of light, falling to 0.2% with two layers and 0.1% with three stacked plies. Ultraviolet blocking across the 280–380 nm band is 99.62% for one layer, 99.94% for two layers, and 100% for three layers. Measured haze is 98.14%, 98.16% and 98.17% for one, two and three layers respectively; the note states that this very high haze is characteristic of the matte embossed surface, which assists de-airing during lamination and does not affect the finished panel appearance, since the film is fused between the glass plies.

The measured mechanical properties include tensile strength of 13.7 MPa, elongation at break of 561.1%, water absorption below 0.1%, adhesion to glass of 120.2 N/cm, and adhesion to PET of more than 40 N/cm. The crosslink degree of 72.2% was determined by xylene extraction: specimens were refluxed in xylene at 140 ± 3 °C for five hours, then dried in a vacuum oven at 140 ± 3 °C for three hours. Recommended lamination is 80 °C for 20 minutes followed by 120 °C for 60 minutes. Storage is at ambient temperature, protected from sunlight, sealed and without heavy loading, with a shelf life of eight months in sealed packaging. The note concludes that the CNCGLASS 0.38 mm ultra-white opaque EVA interlayer film passed the full QC inspection, with appearance, optical, mechanical and crosslinking requirements all conforming, and that the film is qualified as a white opaque interlayer for architectural laminated glass in privacy, spandrel and decorative applications.

Contact for this work is Peter Lin at CNC Ucolin Interlayer Technology Co., Ltd. (brand CNCGLASS), SHENZHEN, GD, CHINA, email cnc@cncglass.com.

Leave a Reply

Your email address will not be published. Required fields are marked *